BATTERY SPECIFICATIONS

Application & Group	Cold Cranking Amps	Amp Hr. Rating
Talon - Non-Turbo (Group 86)
A/T	525	60
M/T	430	60

FLUID CAPACITIES

Application

⁽¹⁾ Quantity

Crankcase (Includes Filter) ⁽²⁾

4.5 Qts. (4.3L)

Cooling System ⁽³⁾

7.4 Qts. (7.0L)

Automatic Transaxle (Mopar ATF Plus Type 7176)

Drain & Refill

⁽⁴⁾ 4.0 Qts. (3.8L)

Dry Refill

9.1 Qts. (8.6L)

Manual Transaxle ⁽⁵⁾

2.1 Qts. (1.9L)

Power Steering Fluid

(Mopar ATF Plus Type 7176)

1.9 Pts. (.9L)

⁽¹⁾	Approximate quantity listed.

⁽²⁾	Use an API engine oil that is certified for gasoline engines on all engines.

⁽³⁾	Quantity includes heater and coolant recovery tank.

⁽⁴⁾

Add this amount of fluid. Start engine and shift transaxle through all gears and back to Park. Add additional fluid to bring fluid level to 1/8" below the ADD mark on dipstick. Recheck fluid level with transaxle at normal operating temperature. Adjust fluid level so fluid level is within the HOT range on dipstick.

⁽⁵⁾	Use only Mopar MS9417 manual transaxle fluid.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Engine Controls - Specifications - Non-Turbo: Capacities

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?