1998 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Toe-In Adjustment (Front)

NOTE: When performing four-wheel alignment, rear camber and toe adjustment must be set to specification first, then adjust front wheels to specification.

With steering wheel centered, loosen tie rod end lock nuts. While holding steering rod dust boots stationary, rotate tie rods to obtain specified toe-in. See WHEEL ALIGNMENT SPECIFICATIONSΒ  table. See Fig 1. Tighten lock nuts to specification. See TORQUE SPECIFICATIONSΒ  table.

On 1998 Concorde and Intrepid, loosen tie rod adjustment pinch bolt. Rotate adjustment sleeve to set to specification. Ensure exposed threaded area does not exceed .79" (20 mm). Tighten pinch bolt to specification. See TORQUE SPECIFICATIONSΒ  table.

Fig 1: Adjusting Toe-In
G90F12836Courtesy of CHRYSLER LLC
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.