Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Starter Specifications
STARTER SPECIFICATIONS - DIRECT DRIVE
| Application | Specification |
|---|---|
| Number Of Teeth | 8 |
| Rated Output At 12 Volts | .95 Kw |
STARTER SPECIFICATIONS - REDUCTION GEAR
| Application | Specification | ||||
|---|---|---|---|---|---|
| Carbon Brush | |||||
| Minimum Length | (1) | ||||
| Commutator | |||||
| Diameter | |||||
| Standard | 1.158" (29.4 mm) | ||||
| Minimum | 1.118" (28.4 mm) | ||||
| Mica Undercut Depth | .020" (0.5 mm) | ||||
| Runout | |||||
| Standard | .002" (.05 mm) | ||||
| Maximum | .004" (.10 mm) | ||||
| Maximum Amps | 90 | ||||
| Minimum RPM | 3000 | ||||
| Number Of Teeth | |||||
| Non-Turbo | 10 | ||||
| Turbo | 8 | ||||
| Pinion Gap | .020-.079" (0.5-2.0 mm) | ||||
| Rated Output At 12 Volts | |||||
| Canada | 1.4 Kw | ||||
| US | 1.2 Kw | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.