1997 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Ignition Switch Test

WARNING: All models are equipped with Supplemental Restraint System (SRS). To avoid injury from accidental air bag deployment, read and carefully follow all WARNINGS and SERVICE PRECAUTIONS. See AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section. Failure to do so could result in accidental deployment of air bags and possible personal injury.
  1. Disable air bag. See AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section. Remove instrument cluster undercover. Remove steering column covers to locate ignition switch 6-pin connector. Disconnect ignition switch 6-pin connector.
  2. Put ignition switch in ON position. Using an ohmmeter, check continuity between switch terminals No. 1 (White wire), No. 2 (Black/White wire), No. 4 (Blue/Black) and No. 6 (Blue wire). If continuity is not present, replace ignition switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.