1997 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
A/C Blower Motor Switch On A/C control panel. See Figure .
A/C Dual Pressure Switch (Non-Turbo) Right front of engine compartment. See Figure .
A/C Refrigerant Temperature Switch On A/C compressor.
A/C Switch On A/C control panel. See Figure .
A/T Kickdown Servo Switch (Turbo) On top of transmission. See Figure .
A/T Overdrive Switch Under center console. See Figure .
Back-Up Lamp Switch (M/T) (Non-Turbo) On top of transmission. See Figure .
Back-Up Lamp Switch (M/T) (Turbo) On top of transmission. See Figure .
Brake Fluid Level Switch (Non-Turbo) On brake fluid reservoir. See Figure .
Brake Fluid Level Switch (Turbo) On brake fluid reservoir. See Figure .
Clutch Pedal Position Switch (M/T) On clutch pedal bracket. See Figure .
Engine Coolant Level Switch (Turbo) On rear of cylinder head, below water inlet. See Figure .
Oil Pressure Switch (Non-Turbo) On oil filter housing. See Figure .
Oil Pressure Switch (Turbo) On oil filter housing. See Figure .
Parking Brake Switch At base of parking brake lever. See Figure .
Park/Neutral Position Switch (Turbo) On top of transmission. See Figure .
Power Steering Pressure Switch (Non-Turbo) On power steering pump. See Figure .
Power Steering Pressure Switch (Turbo) On power steering pump. See Figure .
Stop Lamp Switch On brake pedal bracket. See Figure .
Transaxle Range Switch (Non-Turbo) On top of transmission. See Figure .
Windshield Washer Fluid Level Switch (Non-Turbo) In left rear of engine compartment. See Figure .
Windshield & Rear Washer Fluid Level Switch (Turbo) In left rear corner of vehicle. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.