Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS
| Component | Component Location |
|---|---|
| Air Bag Clock Spring | At top of steering column. See Figure . |
| Amplifier | Under passenger front seat. |
| Data Link Connector | Under left side of dash, near center console. See Figure . |
| Engine Speed Detection Connector | Right rear of engine compartment, near battery. |
| Fuel Pump Check Connector (Turbo) | Right rear of engine compartment, near battery. See Figure . |
| Ignition Timing Connector (Turbo) | Near center of cowl. See Figure . |
| Pulse Generators "A" & "B" (Turbo) | On side of transmission. See Figure . |
| Resistor (W/ABS Or Auto Cruise Control System) | Behind center of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.