1997 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS

Component Component Location
G1 (Non-Turbo) On front of right front fender. See Figure .
G1 (Turbo) On front of right front wheelwell. See Figure .
G2 At front of right front footwell. See Figure .
G3 (Non-Turbo) On left center of firewall. See Figure .
G3 (Turbo) On right rear of engine compartment. See Figure .
G4 (Non-Turbo) On left front shock tower.
G4 (Turbo) On right side of firewall. See Figure .
G5 Behind left side of dash. See Figure .
G6 Below liftgate latch.
G7 On left rear of liftgate.
G8 Below left front seat.
G9 Below right front seat.
G10 Below center of dash. See Figure .
G11 (Non-Turbo) On front of left front fender. See Figure .
G11 (Turbo) On front of left front fender. See Figure .
G12 (Non-Turbo) Behind left headlight. See Figure .
G13 (Non-Turbo) On left rear of engine. See Figure .
G13 (Turbo) On rear of engine. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.