Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Reprogramming Procedure
- Ensure ignition is off. Connect scan tool to Data Link Connector (DLC). See Fig 1 . Close all doors. Turn ignition switch to ACC position, then turn back to LOCK position.
- Press any button on transmitter. Press same button 2 more times within 10 seconds. After registration is complete, doors will lock, then unlock.
- Registration mode is completed under the following conditions:
- Registration of 2 transmitter codes are completed.
- One minute has passed since registration mode setting was completed.
- Scan tool is disconnected.
- Ignition is turned on.
- Any door is opened.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.