Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
System Inputs
The following inputs are used by the Transmission Control Module (TCM) to determine proper vehicle shift points.
- Circuit K22 is used to provide the TCM with the throttle position
- Circuit K4 is used to provide the throttle position sensor ground to the Powertrain Control Module (PCM)
- Circuit K24 is used to provide the TCM with the engine speed input
- Circuit K22 is used to provide the TCM with the throttle position
- Circuit K4 is used to provide the throttle position sensor ground to the Powertrain Control Module (PCM)
- Circuit K24 is used to provide the TCM with the engine speed input
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
