1996 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE

Circuit Operation

CIRCUIT OPERATION
Circuit A14 is used to provide a constant battery feed to the Powertrain Control Module (PCM), cavity 46. This circuit originates in the Power Distribution Center (PDC) and is protected by a 20 Amp fuse located in cavity B. It is also spliced and provides power for the Automatic Shut Down (ASD) relay contact side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.