1996 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE

Sensor Test

Coolant Temperature Sensor Resistance Test:

Factory service manual diagram





1. With the key off, disconnect wire harness connector from coolant temperature sensor (Fig. 58 or Fig. 59).
2. Connect a high input impedance (digital) volt ohmmeter to terminals A and B. The ohmmeter should read as follows:
- Engine/Sensor at nonmal operating temperature around 200° F should read approximately 700 to 1,000 ohms.
- Engine/Sensor at room temperature around 70° F ohmmeter should read approximately 7,000 to 13,000 ohms.
3. Test the resistance of the wire harness between the PCM 40-way connector terminal 26 and the sensor harness connector.
- If the resistance is greater than 1 ohm, repair the wire harness as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.