Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Using MIL
Faults may be retrieved using MIL on instrument panel or scan tool. To activate MIL, turn ignition key ON-OFF-ON-OFF-ON within 5 seconds. Count number of times MIL flashes on and off. This represents the Diagnostic Trouble Code (DTC). Following is a brief description of DTCs and conditions.
- Code 12
Battery feed to PCM has been interrupted within last 50-100 engine starts. PCM monitors this circuit whenever ignition is on. - Code 41
Generator field control fails to switch properly. PCM monitors this circuit whenever ignition is on. - Code 44
Battery temperature sensor voltage is out of range. PCM monitors this circuit whenever ignition is on. - Code 46
Charging system voltage is more than one volt above desired control voltage for more than 20 seconds. PCM monitors this signal whenever engine is running. - Code 47
Charging system voltage is at least one volt less than desired control voltage for more than 20 seconds. No significant change in voltage is detected during active test of generator. PCM monitors this signal whenever engine speed is more than 1500 RPM.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
