Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Retrieving DTCS: Notes
NOTE:
Self-diagnostic tests are written specifically for Chrysler's DRB-III scan tool, which will be referred to as scan tool during testing procedures. A generic scan tool should not be used for tests in this article, as it is not capable of performing test functions associated with DTCs that occur. Malfunction Indicator Light (MIL), also known as CHECK ENGINE light (located on instrument panel), may also be used for system diagnostics, but has limited diagnostic capability.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
