1996 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Unit

The ECM is located under center of dash, behind center console. See Fig 1 . AWD and 2WD models each have their own specific ECM. ECM receives input voltage signals from a variety of input devices. ECM compares each voltage input signal to a preset parameter which is programmed into ECM. ECM instantly analyzes each input voltage signal and adjusts output voltage signals accordingly. This allows for lower emissions while maintaining fuel economy and driveability.

Fig 1: Locating Engine Control Module (ECM)
G95H35763Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.