Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Eagle Summit BaseFACTORY OEM SERVICE PROCEDURE
Summit Wagon
- With A/C switch in LOW position, ignition on and engine coolant temperature greater than 185°F (85°C), thermosensor completes path to ground, closing radiator fan motor relay contacts and providing current to radiator fan motor.
- With A/C switch in HIGH position and ignition on, power supply from automatic compressor control unit causes condenser fan motor relay to turn on, using a resistor to cause condenser fan and radiator cooling fan to operate at low speed.
- If pressure switch is activated by excessive pressure or if thermosensor is on when engine coolant temperature exceeds 185°F (85°C), condenser fan motor control relay is activated, causing condenser fan and radiator cooling fan to operate at high speed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.