Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
Torque Specifications
COMPONENT TORQUE/FT. LBS.
Adjuster Lock Bracket Screws 40 [01]
Cooler Line Connector 13
Differential Cover To Case 21
Differential Drain Plug 5
Differential Fill Plug 35
Driveplate To Crankshaft Bolts 75
End Cover To Case Screw 21
Filter Retainer 40 [01]
Input Sensor To Case 20
Manual Lever To Valve Body 40 [01]
Oil Pan To Case Screw 14
Output Sensor To Case 20
Output Shaft Stake Nut 200
Park Sprag Retention Screw 40 [01]
Pressure Check Plug (Wet) 45 [01]
Pump To Case Bolt 22
Solenoid Assembly To Transfer Plate 50 [01]
Solenoid Wiring Connector Retainer 50 [01]
Torque Converter To Driveplate 60
Transfer Plate To Case 9
Valve Body Screw 40 [01]
Wiring Harness Tie Down Bolt 50 [01]
Footnote:
[01] -- Inch lbs.
Adjuster Lock Bracket Screws 40 [01]
Cooler Line Connector 13
Differential Cover To Case 21
Differential Drain Plug 5
Differential Fill Plug 35
Driveplate To Crankshaft Bolts 75
End Cover To Case Screw 21
Filter Retainer 40 [01]
Input Sensor To Case 20
Manual Lever To Valve Body 40 [01]
Oil Pan To Case Screw 14
Output Sensor To Case 20
Output Shaft Stake Nut 200
Park Sprag Retention Screw 40 [01]
Pressure Check Plug (Wet) 45 [01]
Pump To Case Bolt 22
Solenoid Assembly To Transfer Plate 50 [01]
Solenoid Wiring Connector Retainer 50 [01]
Torque Converter To Driveplate 60
Transfer Plate To Case 9
Valve Body Screw 40 [01]
Wiring Harness Tie Down Bolt 50 [01]
Footnote:
[01] -- Inch lbs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.