Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
Helpful Information
Circuit K6 is spliced and provides 5 Volts to the A/C pressure switch and the map sensor.
On automatic transmission vehicles, circuit K22 is spliced and provides an input to the Transmission Control Module (TCM)
Circuit K4 splices to supply ground for the signals from the following:
- Intake air temperature sensor
- Camshaft position sensor
- Manifold absolute pressure sensor
- Ambient temperature sensor
- A/C pressure switch
- Crankshaft position sensor
- Flex fuel sensor
On automatic transmission vehicles, circuit K22 is spliced and provides an input to the Transmission Control Module (TCM)
Circuit K4 splices to supply ground for the signals from the following:
- Intake air temperature sensor
- Camshaft position sensor
- Manifold absolute pressure sensor
- Ambient temperature sensor
- A/C pressure switch
- Crankshaft position sensor
- Flex fuel sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.