Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
State Display Inputs and Outputs
NOTE: Since switch inputs to the PCM have only two recognized states, HIGH and LOW, the PCM cannot recognize, an open circuit, a shorted circuit, or a defective switch.
- If a switch state seen by the PCM changes when the switch is operated, it can be assumed that the switch and circuit to the PCM are functional.
Procedure:
1. Connect the scan tool to the vehicle and access the State Display screen.
2. Access Inputs and Outputs.
3. The following is a list of accessible Inputs and Outputs:
State Display Inputs
Park/Neutral Switch (Automatic Transaxle Only)
Speed Control Resume
Brake Switch
Speed Control ON/OFF
Speed Control Set
A/C Switch Sense
Z2 Voltage Sense
B1 Voltage Sense
State Display Outputs
S/C (Speed Control) Vent Solenoid
S/C (Speed Control) Vacuum Solenoid
Torque Converter Clutch Solenoid (3 Speed Automatic Transaxle)
A/C Clutch Relay
EMR Lamp
Auto Shutdown Relay
Radiator Fan Relay
Purge Solenoid
Malfunction Indicator Lamp (MIL) - (Check Engine Lamp)
4. Follow scan tool manufacturer's instructions to check operation of circuits.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
