1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor: Service and Repair

WARNING: Avoid physical contact with hot exhaust components.

CAUTION: Do not pull on or cut sensor wires, when removing sensor.

CAUTION: Use of excessive force may damage threads in exhaust manifold or pipe.

REMOVAL
1. Disconnect oxygen sensor electrical connector.
2. Using a suitable tool (Snap-On socket YA8875, or equivalent), carefully remove the sensor from exhaust manifold or pipe. (Slightly tightening the sensor before removal may ease removal.)
3. Clean threads in exhaust manifold with an 18 mm X 1.5 + 6E tap.

INSTALLATION
1. If a new sensor is being used, verify that the threads are coated with anti-seize compound, before installing in manifold or pipe.
2. If sensor is being reused, coat sensor threads with a nickel based anti-seize compound, (Loctite 771-64 or equivalent).

CAUTION: Do not use graphite or other anti-seize compounds.

3. Install sensor, and tighten to 27 Nm (20 ft-lbs).
4. Connect wiring.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.