Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
Speed Control
PURPOSE
This input informs Powertrain Control Module (PCM) of speed control status
OPERATION
The speed control system provides four different input signals to the PCM; ON/OFF, SET, and RESUME.
The input, ON, indicates to the PCM that the speed control system has been activated by the driver.
The input, SET, indicates to the PCM that a specific vehicle speed has been selected by the driver.
The input, RESUME, indicates to the PCM that the previously SET speed has been requested by the driver.
The input, OFF, indicates to the PCM that the speed control system has been deactivated by the driver.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.