Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
Switch Test
1. Remove ON/OFF speed control switch assembly, then disconnect two way connector.
2. Using a suitable ohmmeter connect one lead to pin No. 1 and the other to pin No. 2. Press OFF button, resistance should be 0 to 5ohms, press ON button, resistance should be between 644 and 668 ohms.
3. If not within specification, replace switch.
4. Remove SET/RESUME speed control switch assembly, then disconnect two way connector.
5. Using a suitable ohmmeter connect one lead to pin No. 1 and the other to pin No. 2, meter should read no continuity. Press SET button, resistance should be 1978-2022 ohms, press RESUME button, resistance should be 5558-5682 ohms.
6. If resistance is not within specification, replace switch.
2. Using a suitable ohmmeter connect one lead to pin No. 1 and the other to pin No. 2. Press OFF button, resistance should be 0 to 5ohms, press ON button, resistance should be between 644 and 668 ohms.
3. If not within specification, replace switch.
4. Remove SET/RESUME speed control switch assembly, then disconnect two way connector.
5. Using a suitable ohmmeter connect one lead to pin No. 1 and the other to pin No. 2, meter should read no continuity. Press SET button, resistance should be 1978-2022 ohms, press RESUME button, resistance should be 5558-5682 ohms.
6. If resistance is not within specification, replace switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
