1995 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE

Cruise Control Switch: Service and Repair

The speed control switches are mounted in the steering wheel and wired through the clock spring device under the steering wheel hub.

If removal of air bag module is necessary, refer to Air Bag/Service and Repair.

1. Turn ignition switch to Off position.
2. Remove two screws from back side of each switch on steering wheel.
3. Rock switch away from air bag or horn pad while lifting switch out of steering wheel. Do not point air bag module toward yourself or others when performing this operation to prevent injury in case of accidental deployment of air bag module.
4. Disconnect 2-way electrical connector.
5. Reverse procedure to install, sliding the forward edge of switch under air bag or horn pad. Line up locating pins on switch with holes in steering wheel frame. Do not point air bag module toward yourself or others when performing this operation to prevent injury in case of accidental deployment of air bag module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.