1995 Eagle Summit DLFACTORY OEM SERVICE PROCEDURE

Power Circuits

WARNING: This page is about a different car, the 1996 Mitsubishi Diamante, 1996 Mitsubishi 3000GT, and 1996 Dodge Stealth. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition on. Check for battery voltage on both PCM power terminals. See Fig 1. If battery voltage is not present, check operation of MFI relay. See RELAYSΒ  under MOTORS, RELAYS & SOLENOIDS.

POWERTRAIN CONTROL MODULE (PCM) LOCATION

Application Location
Stealth & 3000GT Behind Center Console
All Others Behind Right Side Of Instrument Panel (Glove Box)
Fig 1: PCM Terminal ID (Diamante, Stealth & 3000GT)
G96C09836Courtesy of MITSUBISHI MOTOR SALES OF AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.