Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Summit DLFACTORY OEM SERVICE PROCEDURE
Control Unit (Pcm) Test: Notes
WARNING: This page is about a different car, the 1996 Mitsubishi Diamante, 1996 Mitsubishi 3000GT, and 1996 Dodge Stealth. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For Powertrain Control Module (PCM) location, see POWERTRAIN CONTROL MODULE (PCM) LOCATIONΒ table. To identify PCM power and ground terminals, see appropriate pin voltage chart in PIN VOLTAGE CHARTS
article. To identify PCM power and ground circuits, see appropriate WIRING DIAGRAM in WIRING DIAGRAMSΒ section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
