1995 Eagle Summit DLFACTORY OEM SERVICE PROCEDURE

Code 61: Transaxle Control Module Signal

NOTE: For component terminal identification, see TERMINAL IDENTIFICATION  in this article. For appropriate WIRING DIAGRAMS, see WIRING DIAGRAMS  section.
  1. Disconnect Transaxle Control Module (TCM) and PCM connectors. Ground TCM connector terminal No. 7 (No. 18 on Expo and Summit Wagon). Using DVOM, check continuity between chassis ground and PCM connector terminal No. 116. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  2. Ground TCM connector terminal No. 9 (No. 4 on Expo and Summit Wagon). Check continuity between chassis ground and PCM connector terminal No. 59. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  3. Ground TCM connector terminal No. 108 (No. 17 on Expo and Summit Wagon). Check continuity between chassis ground and PCM connector terminal No. 7. If continuity does not exist, repair wiring harness as necessary. If continuity exists, test is complete. Intermittent problem may exist. See TESTS W/O CODES - 2.4L article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.