Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Eagle Summit DLFACTORY OEM SERVICE PROCEDURE
Sensor Operating Range Charts: Notes
NOTE:
Unless stated otherwise in test procedure, perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance. For connector and terminal identification, see WIRING DIAGRAMS
section.
COOLANT TEMPERATURE SENSOR RESISTANCE
| Application & Temperature °F (°C) | Ohms |
|---|---|
| 32 (0) | 5800 |
| 68 (20) | 2400 |
| 104 (40) | 1100 |
| 176 (80) | 300 |
EGR TEMPERATURE SENSOR RESISTANCE TEST (1)
| Application & Temperature °F (°C) | Ohms | ||
|---|---|---|---|
| 122 (50) | 60-83 | ||
| 212 (100) | 11-14 | ||
|
|||
INTAKE AIR TEMPERATURE SENSOR RESISTANCE
| Application & Temperature °F (°C) | Ohms |
|---|---|
| 32 (0) | 6000 |
| 68 (20) | 2600 |
| 176 (80) | 300 |
OXYGEN SENSOR VOLTAGE TEST (1)
| Application | Volts | ||
|---|---|---|---|
| Lean | 0.6 | ||
| Rich | 1.0 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.