Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
General Specifications
General Engine Specifications
| Engine Type | 60 degree V-6 | |
| Bore | 93.0 Millimeter (mm) | |
| Stroke | 81.0 Millimeter (mm) | |
| Displacement | 3.3 Liter (L) | |
| Compression Ratio | 8.9 To 1 (: 1) | |
| Minimum Compression Pressure | 100 psi | |
| Maximum Variation Between Cylinders | 25 % | |
| Brake Horsepower | 161 at 5300 Horsepower At RPM (hp @ rpm) | |
| Torque | 181 at 2800 Pound Foot At RPM (ft.lb @ rpm) | |
| Firing Order | 1 - 2 - 3 - 4 - 5 - 6 | |
| Cylinder Number (Front to Rear) | Left Bank | 2 - 4 - 6 |
| Right Bank | 1 - 3 - 5 | |
| Lubrication | Pressure Feed-Full Flow Filtration | |
| Oil Pump | Direct Crankshaft Driven Pump | |
| Engine Oil Capacity | With Oil Filter | 5 qts |
| Without Oil Filter | 4.5 qts | |
| Cooling System | Liquid Cooled-Forced Circulation | |
| Cylinder Block | Cast Iron | |
| Crankshaft | Nodular Iron | |
| Cylinder Head | Aluminum Alloy | |
| Connecting Rods | Forged Steel |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.