Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
Engine Oil
TYPE SG, SG/CD*
*Preferred with Turbo engine SG/CD required for 1993 Turbo engine.
CAPACITY, Refill:
3.3L Concorde, Intrepid, Vision 4.3 Liters 4.5 Quarts
3.5L, all 4.8 Liters 5.0 Quarts
All others 3.8 Liters 4.0 Quarts
Capacity shown is without filter. When replacing filter, additional oil may be needed
All engine. above 0°F (-18°C) 10W-30*
2.5L Van, 3.5L & Turbo below 32°F (0°C) 5W-30‡
Non-Turbo ex. 2.5L Van below 100°F (38°C) 5W-30
*Preferred in all Turbo, 2.5L & 3.5L
‡Preferred in all non-Turbo ex. 2.5L Van
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.