Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Eagle Vision V6-201 3.3LFACTORY OEM SERVICE PROCEDURE
Control Module HVAC: Service and Repair
Blower Motor Resistor and Power Module Replacement
REMOVAL
1. Remove lower right under panel access cover silencer duct.
2. Disconnect wiring connector on blower motor module.
3. Remove blower motor module retaining screws.
4. Pull blower motor module out of heater housing.
INSTALLATION
For installation reverse the above procedures.
REMOVAL
1. Remove lower right under panel access cover silencer duct.
2. Disconnect wiring connector on blower motor module.
3. Remove blower motor module retaining screws.
Blower Motor Module:
4. Pull blower motor module out of heater housing.
INSTALLATION
For installation reverse the above procedures.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.