Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Eagle Talon ES, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Switch Test
- Remove steering column covers to locate ignition switch 6-pin connector. Using a voltmeter, backprobe ignition switch 6-pin connector terminal No. 6 (White wire) and check for battery voltage. If battery voltage does not exist, replace main fusible link.
- If battery voltage exists at ignition switch 6-pin connector terminal No.6 (White wire), backprobe ignition switch 6-pin connector terminal No. 5 (Black/Yellow wire) and turn ignition switch to START position. If battery voltage does not exist at terminal No. 5 (Black/Yellow wire) to starter, replace ignition switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.