Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Eagle Talon DL, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Coil (2.0L)
- Disconnect ignition coil connector. Using an ohmmeter, measure primary coil resistance between ignition coil terminals No. 2 and 3. Perform TEST 1. See Fig 1 . Also, measure resistance between ignition coil connector terminals No. 1 and 3. Primary resistance should be .70-.86 ohm at 68°F (20°C).
- With ignition coil connector still disconnected, measure secondary coil resistance. Measure resistance between high-voltage terminals for cylinders No. 1 and 4, and between high-voltage terminals for cylinders No. 2 and 3. Perform TEST 2. See Fig 1 .
- Secondary resistance should be 11,300-15,300 ohms. Replace ignition coil if it does not test as described.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.