Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Eagle Summit Wagon AWD, AutomaticFACTORY OEM SERVICE PROCEDURE
External Pages
These are pages that do not belong to the exact selected vehicle (1994 Eagle Summit Wagon AWD, Automatic), but are still accessible from a link in your vehicle's manual. Be very cautious using repair info from here because these pages may not apply to your vehicle.
- Different variant/trim
- Different car
- Section 1 (Engine/VIN Id)
- Section 2 (Engine Controls - Specifications)
- Section 3 (Engine Controls - Adjustments)
- Section 4 (Engine Controls - System/Component Tests)
- Section 5 (Engine Controls - Tests W/Codes)
- Section 6 (Wiring Diagrams)
- Section 7 (Engine/VIN Id)
- Section 8 (Engine Controls - Basic Testing)
- Section 9 (Vacuum Diagrams)
- Section 10 (Engine Controls - Tests W/O Codes)
- Section 11 (Engine Controls - Remove/Install/Overhaul)
- Section 12 (Engine Controls - Pin Voltage Charts)
- Section 13 (3.0L V6 - VINS [H,J,K])
- Section 14 (Air Bag Restraint System)
- Section 15 (Heater System)
- Section 16 (Suspension - Electronic)
- Section 17 (Suspension - Front (Fwd))
- Section 18 (Suspension - Electronic)
- Section 19 (Wheel Alignment Specifications & Procedures)
- Section 20 (Suspension - Rear (AWD & Fwd))
- Section 21 (Air Bag And Supplemental Restraint System (SRS) Component Inspection & Replacement Tables)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
