Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE
Entering On-Board Diagnostics: Notes
- Before entering on-board diagnostics, refer to PRETEST INSPECTION . Turn ignition off. Attach appropriate 1993 cartridge to DRB-II. Connect DRB-II to CCD bus diagnostic connector. See Figure .
- Turn all accessories off. Turn ignition on. All character positions will glow and copyright information will appear on DRB-II screen for a few seconds. Display will then change to DRB-II menu.
- If DRB-II displays an error message or if screen is blank, refer to VEHICLE COMMUNICATIONS TESTS. Always start at TEST 1A - FAULT MESSAGES .
- The following DRB-II modes can be accessed from DRB-II menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.