Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE
Test 46A - Courtesy Light/Dash Switch Circuit Short
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATIONΒ
. For appropriate wiring diagram, see WIRING DIAGRAMSΒ
at end of article.
- Disconnect headlight switch 8-pin connector from behind switch. Using DRB-II, read courtesy light switch status. If DRB-II does not display COURTESY SW: CLOSED, replace courtesy light dash switch. Perform VERIFICATION PROCEDURE VER-1. If DRB-II does display COURTESY SW: CLOSED, go to next step.
- Disconnect Body Controller Module (BCM). Module is located behind right kick panel. With DRB-II in ohmmeter mode, check resistance on BCM Gray connector terminal No. 11, courtesy light switch sense circuit (Yellow/Red wire). If resistance is less than 5 ohms, repair short to ground in Yellow/Red wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is more than 5 ohms, replace BCM. Perform VERIFICATION PROCEDURE VER-1.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
