1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE

Test 3A - Mic Odometer Problem

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagram, see WIRING DIAGRAMS  at the end of this article.
  1. Using DRB-II, select engine controller. Using DRB-II, read engine controller faults. If a vehicle speed sensor problem is indicated, refer to appropriate G - TESTS W/ CODES article in the ENGINE PERFORMANCE Section.
  2. If a vehicle speed sensor problem is not indicated, turn ignition off. Disconnect Mechanical Instrument Cluster (MIC). Check if odometer has been previously replaced. If odometer has not been replaced, replace odometer. Perform VERIFICATION PROCEDURE VER-1. If odometer has been replaced, replace body controller module. Perform VERIFICATION PROCEDURE VER-1.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.