Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE
Test 36E - Trunk Release Problem
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- If trunk ajar light is the problem, repair problem as necessary. If trunk ajar light is not the problem, access Remote Keyless Entry (RKE) module Black connector. Module is located on top, right side of dashboard.NOTE: RKE module may be accessed by carefully prying each end of dashboard top cover, then lifting rear edge of top cover and sliding cover forward to disengage front clips.
- With DRB-II in voltmeter mode, backprobe RKE Black connector trunk release feed circuit (Black/White wire). Depress trunk release button on transmitter. If voltage is less than 10 volts, replace RKE module. Perform VERIFICATION PROCEDURE VER-1.
- If voltage is more than 10 volts, access trunk release solenoid, located in trunk lid. With DRB-II in voltmeter mode, check voltage on trunk release solenoid connector trunk release feed circuit (Black/White wire). Depress trunk release button on transmitter. If voltage is more than 10 volts, replace trunk release solenoid. Perform VERIFICATION PROCEDURE VER-1. If voltage is less than 10 volts, repair open circuit in Black/White wire. Perform VERIFICATION PROCEDURE VER-1.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.