1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE

Test 36C - Remote Keyless Entry (RKE) Door Lock Relay Problem

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Turn ignition off and disconnect Body Controller Module (BCM) Bone connector. Module is located behind right kick panel. Check voltage on BCM Bone connector terminal No. 9, power door lock switch circuit (Orange/Violet wire). Depress opposite (passenger's) door switch to lock position. If voltage is less than 10 volts, repair open circuit in Orange/Violet wire. Perform VERIFICATION PROCEDURE VER-1.
  2. If voltage is more than 10 volts, turn ignition off and reconnect BCM Bone connector. Turn ignition on and press door lock switch to lock position. If doors do not lock, replace BCM. Perform VERIFICATION PROCEDURE VER-1. If doors lock, problem is in driver's door. Repair wiring.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.