1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE

Test 35C - Auto Door Lock Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATIONΒ  . For appropriate wiring diagram, see WIRING DIAGRAMSΒ  at end of article.
  1. Turn ignition off. Disconnect Body Controller Module (BCM) Bone connector. With DRB-II in voltmeter mode, check voltage on BCM Bone connector terminal No. 9, power door lock switch circuit (Orange/Violet wire). Depress opposite (passenger's) door switch to the lock position. If voltage is less than 10 volts, repair open door lock switch wire. Perform VERIFICATION PROCEDURE VER-1.
  2. If voltage is more than 10 volts, turn ignition off and reconnect BCM Bone connector. Depress door lock switch to lock position. If doors do not lock, replace BCM. Perform VERIFICATION PROCEDURE VER-1. If doors lock, problem is in driver's door. Repair wiring.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.