Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE
Test 15F - OTIS No Response Test
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATIONΒ
. For appropriate wiring diagram, see WIRING DIAGRAMSΒ
at end of article.
- Turn ignition off. Disconnect Overhead Travel Information System (OTIS) 4-pin connector and Body Controller Module (BCM) Bone connector. Module is located behind right kick panel. Using an external ohmmeter, check resistance of Violet/Brown wire between BCM Bone connector terminal No. 8 and OTIS 4-pin connector. If resistance is more than 5 ohms, repair open Chrysler Collision Detection (CCD) bus (+) circuit. Perform VERIFICATION PROCEDURE VER-1.
- If resistance is less than 5 ohms, use an external ohmmeter to check resistance of White/Black wire between BCM Bone connector terminal No. 7 and OTIS 4-pin connector. If resistance is more than 5 ohms, repair open CCD bus (-) circuit. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace OTIS module. Perform VERIFICATION PROCEDURE VER-1.
NOTE:
A break in test sequence occurs at this point. Diagnostic TEST 16A and TEST 16B are related to manual A/C-heater system. Diagnostic TEST 17A through TEST 25G are related to Automatic Temperature Control (ATC) system. Test procedures for manual or automatic A/C-heater systems may be found in appropriate article in the AIR CONDITIONING & HEAT Section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
