1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE

V6 Ignition Timing: 3.0L

  1. Place gear selector in Neutral or Park position. Turn off all lights and accessories. Connect inductive pick-up timing light to No. 1 cylinder.
  2. Start and warm engine to normal operating temperature. Disconnect engine coolant sensor lead wire. Radiator fan should come on, and CHECK ENGINE light on instrument panel should illuminate.
  3. Check timing at crankshaft pulley. If timing is within 2 degrees of specification, DO NOT adjust ignition timing. See V6 IGNITION TIMING table. If timing is not as specified, loosen distributor hold-down bolt, and turn distributor housing until specified timing is obtained.
  4. Recheck timing after distributor hold-down bolt has been tightened. Reconnect coolant lead wire. Erase any fault codes. Remove diagnostic equipment.
V6 IGNITION TIMING

Application Degrees BTDC @ RPM
Except 3.0L (1)
3.0L 12 @ Idle
(1) Ignition timing is computer controlled and is not adjustable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.