Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Eagle Vision ESiFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Control Unit | On ABS hydraulic assembly. |
| Air Bag Sys. Diagnostic Module | Forward of center console, near floor. |
| Blower Motor Power Module | Behind right side of dash, on A/C-heater case. |
| Body Control Module (BCM) | Behind right kick panel. |
| Cooling Fan RFI Module | Mounted between cooling fans. |
| Daytime Running Lights Module | In right front corner of engine bay. |
| Powertrain Control Module (PCM) | In right front corner of engine bay. |
| Remote Keyless Entry Module | Under dash top cover, on passenger side. |
| Transmission Control Module | In left front corner of engine bay. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.