Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Eagle Talon ES, AutomaticFACTORY OEM SERVICE PROCEDURE
DTC / Fault Code References & Definitions: Notes
NOTE:
Fault code 0 (zero) and CHECK ENGINE light illuminated continuously only apply when entering diagnostics using voltmeter. DRB-II will NOT display these 2 conditions.
DTC /FAULT CODES TO TEST REFERENCE
| DTC/Fault Code | Test No. |
|---|---|
| 11 | DR-2A |
| 12 | DR-3A |
| 13 | DR-4A |
| 14 | DR-5A |
| 21 | DR-6A |
| 23 | DR-7A |
| 24 | DR-8A |
| 25 | DR-9A |
| 31 | DR-10A |
| 41 | DR-11A |
| 42 | DR-12A |
| 43 | DR-13A |
| 44 | DR-14A |
DTC / FAULT CODE DEFINITIONS
| DTC/Fault Code | Definition | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| 0 (1) | Normal Condition | ||||||||||
| 11 | O2 Sensor Circuit | ||||||||||
| 12 | Airflow Sensor Circuit | ||||||||||
| 13 | Intake Air Temperature Sensor Circuit | ||||||||||
| 14 | Throttle Position Sensor(TPS) Circuit | ||||||||||
| 21 | Coolant Temperature Sensor Circuit | ||||||||||
| 22 | Crank Angle Sensor Circuit | ||||||||||
| 23 (2) | No. 1 & No. 4 Cylinder TDC Sensor Circuit | ||||||||||
| 24 | Vehicle Speed Sensor (VSS) Circuit | ||||||||||
| 25 | Barometric Pressure Sensor Circuit | ||||||||||
| 31 (3) | Detonation Sensor Circuit | ||||||||||
| 41 | Injector Circuit | ||||||||||
| 42 | Fuel Pump Circuit | ||||||||||
| 43 (4) | EGR Temperature Sensor Circuit | ||||||||||
| 44 (2) | Ignition Coil Circuit/Power Transistor Unit Circuit | ||||||||||
| (5) | Faulty ECU | ||||||||||
|
|||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
