1992 Eagle Talon Base, StandardFACTORY OEM SERVICE PROCEDURE

Connector Identification: Notes

CAUTION: When battery is disconnected, vehicle computer and energy systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION Section before disconnecting battery.
CONNECTOR IDENTIFICATION DIRECTORY

Connector See Figure
Airflow Sensor Connector (Non-Turbo) Figure
Airflow Sensor Connector (Turbo) Figure
Coolant Sensor Connector Figure
Crank Angle/TDC Sensor Connector Figure
ECU Connectors Figure , Figure , Figure
Fuel Injector Resistor Connector Figure
Idle Speed Control Actuator Figure
Ignition Coil Female Connector Figure
Ignition Coil Male Connector Figure
Inhibitor Switch Connector Figure
MPI Control Relay Connector Figure
Oxygen Sensor Connector Figure
Power Transistor Connector Figure
TPS Sensor Connector Figure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.