Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location | |
|---|---|---|
| CRC Filter (1.8L) | On top front of engine. | |
| Diagnostic Connector | Under left side of dash. See Figure . | |
| Diodes | ||
| ABS | In harness, near ABS control unit. See Figure . | |
| Door Ajar Warning | At left quarter panel, near door jam. See Figure . | |
| Fuel Pump Check Connector | On firewall, near battery. | |
| Noise Condenser | In left rear quarter panel and on firewall, near wiper motor. | |
| Ignition Timing Connector | On firewall, near battery. | |
| O2 Sensor Check Connector | Above right side kick panel. | |
| Power Transistor | ||
| 1.8L | On side of distributor. | |
| 2.0L | On side of intake manifold, near ignition coil. | |
| Tachometer Connector (2.0L) | On center of firewall. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.