1992 Eagle Summit Wagon Base, 1.8 D, StandardFACTORY OEM SERVICE PROCEDURE

Sensor Resistance Test

  1. Before testing sensor resistance, ensure pole piece-to-wheel speed sensor tip is clean. Check wheel sensor pole piece for damage. If damaged, replace sensor.
  2. Disconnect wheel speed sensor connector. Inspect sensor wiring harness for broken and pinched wires. Repair or replace as necessary. Using an ohmmeter, measure sensor resistance at the harness connector. See the WHEEL SPEED SENSOR RESISTANCE SPECIFICATIONSΒ  table. If resistance is not within specification, replace sensor. If resistance is within specification, go to GROUND CIRCUIT TEST heading below.
WHEEL SPEED SENSOR RESISTANCE SPECIFICATIONS

Application Ohms
Diamante
Front 1400-2200
Rear 1300-2100
Eclipse & Galant 800-1200
Expo, Summit Wagon & Colt Vista
AWD 800-1200
FWD
Front 800-1200
Rear 550-800
Stealth & 3000GT
AWD 800-1200
FWD
Front 1400-2200
Rear 1300-2100
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.