1992 Eagle Premier ESFACTORY OEM SERVICE PROCEDURE

Test NF-5A - Checking Map Sensor Calibration

  1. Turn engine off. Install vacuum "T" and vacuum gauge in MAP sensor vacuum hose. Start engine, and let it idle. Using DRB-II, observe MAP. If vacuum gauge reading is within one in. Hg, test is complete.
  2. If reading is not within one in. Hg, turn engine off. Disconnect vacuum gauge from MAP sensor vacuum hose. Connect an auxiliary vacuum pump to MAP sensor. Apply 5 in. Hg to MAP sensor. Read and record MAP sensor voltage. Increase vacuum to 20 in. Hg. Read and record MAP sensor voltage. Subtract voltage recorded at 20 in. Hg from voltage recorded at 5 in. Hg.
  3. If difference is 2.3-2.9 volts, repair restriction in vacuum hose to MAP sensor. Perform VERIFICATION PROCEDURE VER-2. If difference is not 2.3-2.9 volts, replace MAP sensor. Perform VERIFICATION PROCEDURE VER-2.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.