Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Eagle Premier ESFACTORY OEM SERVICE PROCEDURE
Ignition Coil Resistance Test
- Remove ignition cables and measure their resistance (3000-12,000 ohms per foot). Replace cable(s) if necessary. Measure primary coil resistance, between B+ (battery) terminal and pin corresponding to cylinder(s) in question. See Figure .
- Measure secondary coil resistance between coil towers of grouped cylinders. Replace ignition coil if primary/secondary coil resistance is incorrect. See IGNITION COIL RESISTANCE table.
IGNITION COIL RESISTANCE - Ohms @ 70-80°F (21-27°C)
| Application | Primary | Secondary |
|---|---|---|
| All Models | .45 - .65 | 7000-14,000 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.