Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Eagle Talon FWD L4-1997cc 2.0L DOHCFACTORY OEM SERVICE PROCEDURE
Cruise Control Module: Testing and Inspection
Fig. 93 Electronic Control Unit Terminal Identification:
Fig. 94 Electronic Control Unit Test, (Part 1 Of 2):
Fig. 94 Electronic Control Unit Test, (Part 2 Of 2):
1. Disconnect ECU connector, then check the connector half on the body side wiring harness.
Fig. 95 Actuator Limit Switch:
2. The indication of *1 shows the limit switch within the actuator becoming as shown. The actuator selector is at the fully closed position when the resistance between terminals 9 and 20 is measured. For this reason, after checking polarity of the tester, the tester's probe should be connected so current flows from terminal 20 to terminal 9.
3. For terminals indicated by the *2, it is necessary to check individual terminal voltages with the ECU's harness connector connected and the ignition switch in the On position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
