Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Check Engine Light Diagnostic Mode
- Turn ignition off. Connect an analog voltmeter to diagnostic connector terminal No. 1 and 12. Diagnostic connector is located next to a junction block above left kick panel. See Fig 1 .
- Ensure all accessories are off. Turn ignition on. Count number of sweeps of voltmeter needle. As an example, one long sweep followed by a short pause followed by 4 short sweeps would indicate a code 14. See Fig 2 .
- Codes will continue to display until ignition is turned off. If CHECK ENGINE light flashes on and off continuously without pausing, this will be read as a zero, indicating a normal condition. This is a system normal condition providing no other fault codes were stored along with this code pattern.
- If CHECK ENGINE light illuminates steadily without flashing, this indicates a faulty ECU. There is no code translation for a CHECK ENGINE light that does not flash. Ensure ECU connectors, pins and terminals are properly connected before replacing an ECU.
- Refer to FAULT CODES table to translate trouble code number to a system fault description. Once trouble area is identified, refer to No Start Test 1 (NS-1) or Driveability Test 1 (DR-1) trouble shooting chart to diagnose problem. Use trouble shooting chart titles to find appropriate chart.
- As an example, engine starts and runs but has a driveability problem. CHECK ENGINE light indicates a code 14. Refer to FAULT CODESΒ table to translate trouble code number to a system fault description.
- When fault code and system fault description are obtained, refer to DR-1 since vehicle has a driveability problem. Follow DR-1 chart until it leads you to a diamond box that asks DOES DISPLAY SHOW FAULT CODE 14?. This box will refer you to DR-5 for diagnosis.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
