Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Crank Angle Sensor (2.0L): Installation
- To install crank angle sensor, reverse removal procedure. Go to step 3). If crank angle sensor reference mark was not made as described in removal procedure, go to next step.
- Turn crankshaft so that No. 1 cylinder is at TDC. Align punch mark on crank angle sensor housing with notch in plate. See Fig 1 . Install crank angle sensor on cylinder head.
- Adjust ignition timing. See appropriate ADJUSTMENTS article. Torque crank angle sensor hold-down bolt to specification. See TORQUE SPECIFICATIONSΒ in this article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
